
2013-2015 Genuine Original Factory OEM Audi A4 S4 RS4 B8.5
(Typ 8K) Bi-Xenon Headlights Headlamp HID D3S Ballast (Xenon
Light Control Unit / Module / Controller / ECU / Computer
/ Starter / Electronic Unit / Steuergerät /Inverter ) ,
D3S Xenon Bulb , Retaining Ring , LED DRL (Daytime Running
Lights) Tagfahrlicht Control Module , LED DRL Control Module,
AFS Leistungsmodul Steuergerät Headlamp Lens Cover , Projector
Reflector , Leveling Motor , Headlight Plastic Lens Cover
Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Audi A4 B8 Facelift
: 4-door saloon/sedan , 5-door Avant (estate/wagon) , Avant
2.0 TDI , A4 Allroad quattro , 1.8L 2.0L 3.2L TFSI , 2.0L
2.7L 3.0L V6 TDI
If your 2013-2015 Audi A4 S4 RS4 B8.5 HID Bi-Xenon Headlight
low beam or Headlamp high beam have problems or Angle Eyes
, daytime running lights DRL LED turn signal , like light
failed failure, flicker , waring light , dipped beam very
dim dimmer, getting dimmer, not working, burnout , flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enough , flashing
, warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your LED headlamps is ok, no need
to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|