
2001-2003 Genuine Original Factory OEM Acura 3.2 CL CL-Xenon
Headlights Headlamp HID D2S D2R Ballast (Xenon Light Control
Unit / Module / Controller / ECU / Computer / Starter /
Electronic Unit / Steuergerät /Inverter ) , D2R Xenon Bulb
Globes , Igniter Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (Second generation)
Acura CL : 4-door
sedan : 3.2 L SOHC VTEC J-series V6
If your 2001-2003 CL 3.2 CL-S OEM Xenon
Headlight low beam or Headlamp high beam have problems or
Angle Eyes , daytime running lights DRL LED turn signal
, like light failed failure, flicker , dipped beam very
dim dimmer, getting dimmer, not working, burnout , flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enough , flashing
, warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your Xenon headlamps is ok, no need
to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|