2009-2014 Genuine Original Factory OEM Acura TSX Second Generation(CU2) Xenon Headlights Headlamp HID D2S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät /Inverter ) , D2S Xenon Bulb , Igniter ， Projector Reflektor Bowls , Headlight Lens Cover Plastic Lenses Yellowish Scratched Lenses Crack Cracked Broken Fading Faded Fogging Foggy Haze Aging Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front

Acura TSX : 4-door Sedan , Station wagon , Sportwagon , 2.4L , 3.5L V6

2.4 L K24Z3 201 hp (150 kW) and 172 lb⋅ft (233 N⋅m) I4
3.5 L J35Z6 280 hp V6 (2010-2014) CU4 chassis code

If your 2009-2014 Acura TSX OEM Xenon Headlight low beam or Headlamp high beam have problems or Angle Eyes , daytime running lights DRL LED turn signal , like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, burnout , flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enough , flashing , warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original led parts like: ballast, led bulb, control unit module , reflector , igniter , or wire harness cable to repair and fix your Xenon headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.


Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.