
2003-2007 100% Genuine Original Factory OEM
Alfa Romeo 166 2st 3st generation Xenon Headlights Headlamp
HID D1S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/Inverter ) , D1S Xenon Bulb , Wires Cable , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Alfa Romeo 166 :
4-door sedan
Petrol:
2.0 L Twin Spark 16V I4
2.0 L Alfa Romeo turbo 12V V6
2.5 L Alfa Romeo 24V V6
3.0 L Alfa Romeo 24V V6
3.2 L Alfa Romeo 24V V6
Diesel:
2.4 L JTD turbo-diesel I5
If your Alfa Romeo 166 OEM HID Bi-Xenon
Headlight low beam or Headlamp high beam have problems or
Angle Eyes , daytime running lights DRL LED turn signal
, like light failed failure, flicker , dipped beam very
dim dimmer, getting dimmer, not working, burnout , flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enough , flashing
, warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your Xenon headlamps is ok, no need
to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|