2004-2012 Genuine Original
Factory Fit OEM Aston Martin DB9 HID Headlights Headlamp
D1S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) , D1S Philips Xenon Bulb ,Ballast to Bulb Wires
Cable , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Aston Martin DB9
: 2+2 seat 2-door coupé , 2-door convertible , 5.9L V12
, Volante , DB9 LM , DBR9 , DBRS9 , Rapide , V8 Vantage
, V12 Vantage , Virage
If your 2004-2012 Aston Martin DB9 HID
Xenon Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , igniter , or wire harness cable to
repair and fix your HID LED headlamps is ok, no need to
cost a lot of money to buy a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|