2007-2012 Genuine Original
Factory Fit OEM Aston Martin DBS V12 HID Headlights Headlamp
D1S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) , D1S Philips Xenon Bulb , Wires Cable Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Aston Martin DBS
: 2-door coupé , 5.935L V12 , DBS Volante
If your 2007-2012 Aston Martin DBS V12
HID Xenon Headlight low beam or Headlamp high beam have
problems, like light failed failure, flicker , dipped beam
very dim dimmer, getting dimmer, not working, flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enoug h , flashing
. warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your HID LED headlamps is ok, no
need to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|