2010-2020 Genuine Original
Factory Fit OEM Aston Martin Rapide V12 HID Headlights Headlamp
D1S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) , D1S Philips Xenon Bulb , Ballast to Bulb
Wires Cable , Projectort Reflector Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Second generation)
Aston Martin Vanquish
: 4-door hatchback , liftback , 5.9 L V12 , Rapide S
5.9 L AM11 V12 (2010–2014)[2]
5.9 L AM29 V12 (2014–2020)[3]
If your 2010-2020 Aston Martin Rapide V12 HID Bi-Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , igniter , or wire harness cable to repair and
fix your HID LED headlamps is ok, no need to cost a lot
of money to buy a whole brand new headlight assembly like
the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|