2007-2012 Genuine Original
Factory Fit OEM Aston Martin Vantage V8 V12 HID Headlights
Headlamp D1S Ballast (Xenon Light Control Unit / Module
/ Controller / ECU / Computer / Starter / Electronic Unit
/ Steuergerät / Inverter ) , D1S Philips Xenon Bulb , Ballast
to Bulb Wires Cable , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Aston Martin Vantage
: 2-door coupé , 2-door roadster,4.3L, 4.7L, 6.0L,V8 ,V12
, ESX Motorsports Super , Prodrive V8 , N400 , V12 Zagato
, N24 , GT4 , GT2 , Rally GT , Grand Am , V12 Vantage GT3
, Vantage S
If your 2007-2012 Aston Martin Vantage
V8 V12 HID Bi-Xenon Headlight low beam or Headlamp high
beam have problems, like light failed failure, flicker ,
dipped beam very dim dimmer, getting dimmer, not working,
flickering blinking , goes one and off , keeps going out
, flashlight , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , go up and down , moving
up and donw , pointing down , distance control defective
, malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enoug h , flashing
. warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your HID LED headlamps is ok, no
need to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|