
2019-2023 Audi A1 Genuine Original Factory OEM Headlights
Headlamp LED Ballast (Xenon Light Control Unit / Module
/ Controller / ECU / Computer / Starter / Electronic Unit
/ Steuergerät /Inverter ) , LED Lamp Bulb Globes , Lens
Cover , Wires Cable , Bulb Holder Projector Reflektor Bowls
Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Audi A1 GB: 5-door
hatchback
1.0 L EA211/EA211 DHSB TFSI I3
1.5 L EA211 EVO series TFSI I4
2.0 L EA888 TFSI I4
25 TFSI/1.0 TFSI , 30 TFSI/1.0 TFSI , 35 TFSI/1.5 TFSI ,
40 TFSI/2.0 TFSI
If your 2019-2023 Audi A1 Full LED Headlight low beam or
Headlamp high beam have problems, like light failed failure,
flicker , dipped beam very dim dimmer, getting dimmer, not
working, flickering blinking , goes one and off , keeps
going out , flashlight , making noise , not bright enough
, not focused , stopped working , turning yellow and the
dashboard displayer have warning light , error code , go
up and down , moving up and donw , pointing down , distance
control defective , malfuncation ,turning pink , not turning
off , gone ping , turned purple ,turned pink , not bright
enoug h , flashing . warning light ,not working properly
, keeps burning out , have any other fault issues, you only
need to change or replace related original led parts like:
ballast, led bulb, control unit module , reflector , or
wire harness cable to repair and fix your led light is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the led ballast.
|