
2007-2012 Genuine Original Factory OEM Audi A5 (Typ 8T)
First Generation Bi-Xenon Headlights Headlamp HID D3S Ballast
(Xenon Light Control Unit / Module / Controller / ECU /
Computer / Starter / Electronic Unit / Steuergerät /Inverter
) , D3S Xenon Bulb , Wires Cable , Retaining Ring , Bulb
Holder Projector Reflektor Bowls LED DRL (Daytime Running
Lights) Tagfahrlicht Power Module , Lens Cover , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Audi A5 8T 8F : 2-door
coupé (8T3) , convertible (8F7) , 5-door liftback , Sportback
(8TA) , S5 coupe 4.2L V8 , RS5 , 1.8L Turbo, 2.0L , 3.0L
, 3.2L , 2.7L , V6 TDI , FSI
1.8 L TFSI I4
2.0 L TFSI I4
3.2 L FSI V6
3.0 L TFSI V6
4.2 L FSI V8
Diesel:
2.0 L TDI I4
2.7 L TDI V6
3.0 L TDI V6
If your 2007-2012 Audi A5 S5 RS5 HID Bi-Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , or wire harness cable to repair and fix your
led light is ok, no need to cost a lot of money to buy a
whole brand new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|