
2016-2018 Audi A6 S6 RS6 C7 Facelift Genuine
Original Factory OEM HID Bi-Xenon Headlights Matrix Full
LED D3S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/Inverter ) , D3S Xenon Globes Bulb , AFS Module , Wires
Cable , Bulb Holder , Xenon LED Projector Reflektor Bowls
, Full LED Matrix Headlamp Control Module , Headlight Leveling
Adjustment Motor , Headlamp Lens Cover Glass Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Audi C7 A6 4G : 4-door
sedan , 5-door station wagon
1.8 L TFSI I4 (China)
2.0 L TFSI I4
2.5 L FSI V6 (China)
2.8 L FSI V6
3.0 L Supercharged V6
2.0 L I4 Diesel
3.0 L V6 Diesel
If your 2016-2018 Audi A6 S6 RS6 C7 HID Bi-Xenon Matrix
LED Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , or wire harness cable to repair and
fix your led light is ok, no need to cost a lot of money
to buy a whole brand new headlight assembly like the car
dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|