
Genuine Original Factory OEM 2010-2014 Audi A7 S7 (Typ 4G)
Sportback Xenon Headlights Headlamp HID D3S Ballast (Xenon
Light Control Unit / Module / Controller / ECU / Computer
/ Starter / Electronic Unit / Steuergerät /Inverter/Converter
) , D3S Xenon Bulb , Wires Cable , Bulb Holder , Projector
Reflektor Bowls Replacement Sale
2012 Audi A7 LED headlight Types
Part will fit : Driver side / Passenger
side / Left / Light / Front
Audi A7 S7 : 5-door
fastback , 2.8L Quattro V6 , 3.0L TFSI , 3.0L TDI V6 Multitronic
If your Audi A7 S7 HID Bi-Xenon LED Headlight low beam
or Headlamp high beam have problems, like light failed failure,
flicker , dipped beam very dim dimmer, getting dimmer, not
working, flickering blinking , goes one and off , keeps
going out , flashlight , making noise , not bright enough
, not focused , stopped working , turning yellow and the
dashboard displayer have warning light , error code , go
up and down , moving up and donw , pointing down , distance
control defective , malfuncation ,turning pink , not turning
off , gone ping , turned purple ,turned pink , not bright
enoug h , flashing . warning light ,not working properly
, keeps burning out , have any other fault issues, you only
need to change or replace related original led parts like:
ballast, led bulb, control unit module , reflector , or
wire harness cable to repair and fix your led light is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|