
2009-2014 Genuine Original Factory OEM Audi
A8 S8 D4 (Typ 4H) Xenon Headlights Headlamp HID D3S Ballast
(Xenon Light Control Unit / Module / Controller / ECU /
Computer / Starter / Electronic Unit / Steuergerät /Inverter
) , D3S Xenon Bulb , Wires Cable , Bulb Holder , AFS Control
Module, Projector Reflektor Bowls Headlight Lens Cover Plastic
Lenses Yellowish Scratched Lenses Crack Cracked Broken Fading
Faded Fogging Foggy Haze Aging Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (Third Generation)
Audi A8 D3 : S8 quattro
, A8 L Security Edition , 3.0L TFSI V6 , 4.2L FSI V8 , 6.3L
W12 , 3.0L V6 TDI , 4.2L V8
If your 2009-2014 Audi A8 A8L S8 D4 HID Bi-Xenon Full LED
Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , or wire harness cable to repair and
fix your led light is ok, no need to cost a lot of money
to buy a whole brand new headlight assembly like the car
dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|