
2019-2020 Genuine Original Factory OEM Audi
Q5 (Typ FY) Full LED Xenon Headlights Ballast (Control Unit
/ Module / Controller / ECU / Computer / Starter / Electronic
Unit / Steuergerät /Inverter ) , D5S Xenon Bulb , DRL LED
Module Box , Wires Cable , Bulb Holder , AFS Curving Light
Control Module Projector Reflektor Bowls , Headlight Plastic
Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Second generation)
Audi Q5 80A : 5-door
SUV
2.0L TFSI I4 (252hp & 273lb-ft) (gasoline)
2.0L TFSI I4 (249hp & 273lb-ft) (MHEV, gasoline) (Q5
45 TFSI quattro)
2.0L TFSI I4 (CDL) (367hp & 369lb.-ft.) (PHEV, gasoline)
(Q5 55 TFSIe)
2.0L TDI I4 (163hp–190hp & 295lb-ft) (diesel)
2.0L TDI I4 (EA189) (204PS & 400Nm.) (MHEV, diesel)
(Q5 40 TDI Quattro)
3.0L TDI V6 (231hp & 368lb-ft) (diesel) (45 TDI)
3.0L TDI V6 (282hp & 457lb-ft) (diesel) (50 TDI)
3.0L TDI V6 (341 hp & 516lb-ft) (diesel) (SQ5, Europe)
3.0L TFSI V6 (349 hp & 369 lb-ft) (gasoline) (SQ5, outside
Europe)
If your 2019-2020 Audi Q5 HID Xenon And Full LED Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , or wire harness cable to repair and fix your
led light is ok, no need to cost a lot of money to buy a
whole brand new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon led control unit box ballast is ok, because from
our many years experience, when the headlight not work,
90% of the problem is on the ballast.
|