
2010-2015 Genuine Original Factory OEM Audi Q7 SUV Xenon
Facelift Headlights Headlamp HID D3S Ballast (Xenon Light
Control Unit / Module / Controller / ECU / Computer / Starter
/ Electronic Unit / Steuergerät /Inverter ) , D3S Xenon
Bulb , AFS Curving Control Module , LED DRL Control Unit
, Leveling Adjustment Motor , Wires Cable , Bulb Holder
, Projector Reflektor Bowls , Plastic Lens Cover, Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Audi Q7 : 5-door
SUV
Petrol:
3.0 L TFSI supercharged V6
3.6 L FSI VR6
4.2 L FSI V8
Diesel:
3.0 L TDI V6
4.2 L TDI V8
6.0 L TDI V12
If your 2010-2015 Audi Q7 HID Bi-Xenon LED DRL Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , or wire harness cable to repair and fix your
led light is ok, no need to cost a lot of money to buy a
whole brand new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|