2013-2015 Genuine Original Factory OEM BMW 7 Series F01 F02 F03 F04 LCI LED Xenon Adaptive Headlights LHD RHD Headlamps Ballast LED Main Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät /Inverter) , Front Light Electronics , LED Bulb Lamp , LED Angle Eyes Module, LED Turn Light Module , LED Daytime Driving Light Module , LED Display for Fan , LED Cornering Light Module , LEAR TMS Module , Wires Cable Harness , Leveling Motor , Plastic Lens Cover , Reflector Bowl , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Fifth generation)

2012-2015 BMW 7Series : 4-door sedan/saloon 4-door extended sedan/saloon

3.0 L turbo I6
4.4 L V8 Turbo
6.0 L V12
3.0 L turbodiesel I6[6]

730Li , 740Li , 750i/Li , 750i/Li xDrive , 750Li High Security , 760i/Li , 760Li High Security , ActiveHybrid7 ActiveHybrid7L , Alpina B7 , 730d , 730ld , 740d xDrive , 750d/Ld xDrive

If your 2013-2015 BMW 7Series F01 F02 F03 F04 OEM Full LED Adaptive and HID Bi-Xenon Headlight low beam or Headlamp high beam have problems or Angle Eyes , daytime running lights DRL LED turn signal , like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, burnout , flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enough , flashing , warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original led parts like: ballast, led bulb, control unit module , reflector , igniter , or wire harness cable to repair and fix your HID LED headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.


Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.