
2009-2013 Genuine Original Factory OEM BMW
7 Series F01 F02 F03 F04 4-Door Saloon Adaptive AFS Xenon
Headlights Headlamp HID D1S Ballast (Xenon Light Control
Unit / Module / Controller / ECU / Computer / Starter /
Electronic Unit / Steuergerät /Inverter ) , D1S Philips
Xenon Bulb , Wires Cable , Bulb Holder , Projector Reflektor
Bowls , LED Turn Light Module , LED Angle Eyes Module ,
Headlight Lens Cover Plastic Lenses Yellowish Scratched
Lenses Crack Cracked Broken Fading Faded Fogging Foggy Haze
Aging Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
2007-2015 BMW 7Series
: 4-door sedan/saloon 4-door extended sedan/saloon
3.0 L turbo I6
4.4 L V8 Turbo
6.0 L V12
3.0 L turbodiesel I6[6]
730Li , 740Li , 750i/Li , 750i/Li xDrive , 750Li High Security
, 760i/Li , 760Li High Security , ActiveHybrid7 ActiveHybrid7L
, Alpina B7 , 730d , 730ld , 740d xDrive , 750d/Ld xDrive
2009-2013 Genuine Original Factory OEM BMW 7 Series F01
F02 F03 F04 HID Bi-Xenon Headlight low beam or Headlamp
high beam have problems or Angle Eyes , daytime running
lights DRL LED turn signal , like light failed failure,
flicker , dipped beam very dim dimmer, getting dimmer, not
working, burnout , flickering blinking , goes one and off
, keeps going out , flashlight , making noise , not bright
enough , not focused , stopped working , turning yellow
and the dashboard displayer have warning light , error code
, go up and down , moving up and donw , pointing down ,
distance control defective , malfuncation ,turning pink
, not turning off , gone ping , turned purple ,turned pink
, not bright enough , flashing , warning light ,not working
properly , keeps burning out , have any other fault issues,
you only need to change or replace related original led
parts like: ballast, led bulb, control unit module , reflector
, igniter , or wire harness cable to repair and fix your
HID headlamps is ok, no need to cost a lot of money to buy
a whole brand new headlight assembly like the car dealer
suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|