2015-2020 Genuine Original Factory OEM Cadillac
Escalade ESV GTM K2XL LED Headlights Headlamp Ballast (LED
Light Control Unit / Module / Controller / ECU / Computer
/ Starter / Electronic Unit / Steuergerät /Inverter ) ,
LED Tail Bulb Lamps, Headlight Lens Cover Plastic Lenses
Yellowish Scratched Lenses Crack Cracked Broken Fading Faded
Fogging Foggy Haze Aging Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Cadillac Escalade
ESV GMT K2XL : 4-door SUV
6.2L EcoTec3 L86 V8
If your 2015-2020 Cadillac Escalade ESV OEM LED Projector
Headlight low beam or Headlamp high beam have problems or
Angle Eyes , daytime running lights DRL LED turn signal
, like light failed failure, flicker , dipped beam very
dim dimmer, getting dimmer, not working, burnout , flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enough , flashing
, warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your LED Adaptive headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit LED control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|