2020-2025 Genuine Original Factory OEM Chevrolet Chevy Corvette C8 Z06 Also Called : GMSV Chevrolet Corvette (Australia) Full LED Dual LED Projector Headlight LHD RHD Headlamp Ballast (LED Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät /Inverter ) , Module, Projector Reflector, Plastic Lens Cover , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front

Chevrolet Chevy Corvette C8 : 2-door targa top , 2-door retractable hardtop convertible

Engine 6.2 L LT2 crossplane OHV V8 (Stingray and E-Ray)
5.5 L LT6 flat-plane DOHC V8 (Z06)
5.5 L LT7 twin-turbo flat-plane DOHC V8 (ZR1)
Electric motor 1x Permanent magnet synchronous motor (E-Ray)
1LT , 2LT , 3LT , FE1, FE3 , FE4 , GT1 , GT2 , 1LZ , 2LZ , 3LZ , ZR1

If your 2020-2025 Chevrolet Chevy Corvette C8 Full LED Headlight low beam or Headlamp housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.


Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon LED control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.