2010-2014 Genuine Original Factory OEM Chrysler
200 Also Called : Lancia Flavia Xenon Headlights Headlamp
HID D3S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/Inverter ) , D3S Philips Xenon Globes Bulb , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Chrysler 200 : 4-door
sedan 2-door convertible , 2.4L , 3.6L V6 , 200LX , Touring
, Limited , 200S
2.4 L World I4
3.6 L Pentastar V6
If your 2010-2014 Chrysler 200 OEM HID Xenon
Headlight low beam or Headlamp high beam have problems or
Angle Eyes , daytime running lights DRL LED turn signal
, like light failed failure, flicker , dipped beam very
dim dimmer, getting dimmer, not working, burnout , flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enough , flashing
, warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your Xenon headlamps is ok, no need
to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|