Genuine Original Factory OEM Chrysler 300
300C First generation Xenon Headlights Headlamp HID D1S
Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/Inverter ) , D1S Osram Xenon Bulb , Headlight Lens Cover
, Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Chrysler 300 : 4-door
convertible , sedan , station wagon , Touring , 2.7L 3.0L
3.5L V6 , 5.7L 6.1L V8 , 300C , SRT-8 , SRT , 300S , ASC
Helios 300 , Executive Series 300 , Heritage Edition , Limited
If your 2005-2010 Chrysler 300C OEM HID Xenon Headlight
low beam or Headlamp high beam have problems or Angle Eyes
, daytime running lights DRL LED turn signal , like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, burnout , flickering blinking , goes
one and off , keeps going out , flashlight , making noise
, not bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enough , flashing , warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , igniter , or wire harness cable to repair and
fix your Xenon headlamps is ok, no need to cost a lot of
money to buy a whole brand new headlight assembly like the
car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|