
2010-2013 Genuine Original Factory OEM Dodge
Durango Xenon Headlights Headlamp HID D1S Ballast (Xenon
Light Control Unit / Module / Controller / ECU / Computer
/ Starter / Electronic Unit / Steuergerät /Inverter ) ,
D1S Osram Gas Discharge Xenon Bulb , Wires Cable Connector
, Leveling Motor Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Third Generation )
Dodge Durango WD
: Full-size SUV , 3.6 L Pentastar V6 , 5.7 L Hemi V8 , Express
, Crew , CrewLux , Citadel ,Heat , R/T
3.6 L Pentastar V6
5.7 L Hemi V8
6.4 L Hemi 392 Apache V8
6.2 L SRT Hellcat Supercharged V8
Express , crew , SXT Plus , Limited , GT
Plus , R/T , Citadel , Pursuit , SRT , SRT Hellcar , Special
service package
05182395AD , 68086319AD
If your 2011-2013 Dodge Durango OEM HID Bi-Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , or wire harness cable to repair and fix your
led light is ok, no need to cost a lot of money to buy a
whole brand new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|