
2013-2019 Genuine Original Factory OEM Dodge
Sprinter W906 2500 3500 Also Called : Freightliner Sprinter
Xenon Headlights Headlamp HID D1S Ballast (Xenon Light Control
Unit / Module / Controller / ECU / Computer / Starter /
Electronic Unit / Steuergerät /Inverter ) , D1S Philips
Gas Xenon Bulb , Wires Cable , Bulb Holder Ring , Projector
Reflektor Bowls , Plastic Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Second generation)
Dodge Sprinter :
3.0 L V6 , 3.5L V8
2-door pickup truck
4-door van
4-door minibus
1.8L I4 M271
2.1L I4 OM646 CDI
2.1L I4 OM651 CDI
3.0L V6 OM642 CDI
3.5L V6 M272
4x4
If your 2013-2019 Dodge Sprinter W906 OEM HID Bi-Xenon
Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , or wire harness cable to repair and
fix your led light is ok, no need to cost a lot of money
to buy a whole brand new headlight assembly like the car
dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|