
2016-2018 Genuine Original Factory OEM Ferrari 488
F142M GTB Spider Front Bi-Xenon Headlights Headlamp HID
D3S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , D3S Osram Gas Discharge Xenon Bulb Wires Cable,
Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Ferrari 488 : 2-door
berlinetta , 2-door spider , 488 Pista , J50 , SP38 Deborah
, GTE , GT3
If your 2016-2018 Ferrari 488 F142M GTB Spider OEM HID
Xenon headlight have problems like: light failed failure,
very dim dimmer, dipped , waring light , dipped beam, keeps
going out , not working, flickering , error , fault , goes
on and off out , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enough , flashing . warning light ,not
working properly , keeps burning out , or have any other
issues, you only need to change or replacement original
xenon parts like: ballast, gas discharge bulb, igniter or
wire harness, cable to repair your HID headlamp is ok, no
need to cost a lot of money to buy high price a whole brand
new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|