2016-2020 Ferrari GTC4 Lusso Genuine Original Factory OEM Front Bi-Xenon LHD RHD Headlights Headlamp HID D3S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät /Inverter ) , D3S Osram Gas Discharge Xenon Bulb Wires Cable Harness, Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front

Ferrari GTC4Lusso : 3-door shooting brake

3.9 L F154 BD twin-turbocharged V8 (GTC4Lusso T)
6.3 L F140 ED V12 (GTC4Lusso)
Ferrari BR20

L90112272 , L90112265 , L90112264 , 329985 , 329983 , 329986

If your 2017-2020 Ferrari GTC4 Lusso OEM HID Bi-Xenon Headlight low beam or Headlamp high beam have problems, like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enoug h , flashing . warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original xenon parts like: ballast, led bulb, control unit module , reflector , or wire harness cable to repair and fix your led light is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.