2013 Genuine Original Factory Ford Fusion
Xenon Headlights Headlamp HID D3S Ballast (Xenon Light Control
Unit / Module / Controller / ECU / Computer / Starter /Sation
/ Electronic Unit / Steuergerät /Inverter ) , D3R Osram
Gas Discharge , Xenon Bulb Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Twelfth generation)
Ford Fusion : 2.5
L Duratec 25 I4 , 3.0 L Duratec 30 V6 , 3.5 L Duratec 35
V6 , Hybrid , S, SE, SEL and Sport
Gasoline:
2.3 L Duratec 23 I4
2.5 L Duratec 25 I4
3.0 L Duratec 30 V6
3.5 L Duratec 35 V6
Gasoline Hybrid:
2.5 L Duratec 25 I4
If your 2013 Ford Fusion OEM HID Xenon Headlight low beam
or Headlamp high beam have problems, like light failed failure,
flicker , dipped beam very dim dimmer, getting dimmer, not
working, flickering blinking , goes one and off , keeps
going out , flashlight , making noise , not bright enough
, not focused , stopped working , turning yellow and the
dashboard displayer have warning light , error code , go
up and down , moving up and donw , pointing down , distance
control defective , malfuncation ,turning pink , not turning
off , gone ping , turned purple ,turned pink , not bright
enoug h , flashing . warning light ,not working properly
, keeps burning out , have any other fault issues, you only
need to change or replace related original xenon parts like:
ballast, led bulb, control unit module , reflector , or
wire harness cable to repair and fix your led light is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|