2000-2007 Genuine Original Factory Ford Mondeo ST220 Mk3 Also Called: Ford Mondeo Metrostar Front Xenon Headlights LHD RHD Headlamp HID D2S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät /Inverter ) , D2S Philips Gas Discharge , Ignition Xenon Bulb , Leveling Motor Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front(Third Generation )

Ford Mondeo Mk3 : 4-door saloon , 5-door liftback , 5-door estate

Petrol engines:
1.8 L Mazda L8 Duratec I4
1.8 L Mazda L Series SCi I4
2.0 L Mazda LF Duratec I4
2.5L Duratec 24v V6
3.0 L Duratec 30 V6
Diesel engines:
2.0L TDDi I4
2.0L ZSD TDCi I4 common rail
2.2L ZSD TDCi I4 common rail

titanium x sport ST220 Lx MK3 Estate

If your 2000-2007 Ford Mondeo ST220 Mk3 OEM HID Xenon Headlight low beam or Headlamp high beam have problems, like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enoug h , flashing . warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original xenon parts like: ballast, led bulb, control unit module , reflector , or wire harness cable to repair and fix your led light is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.