2008-2014 Genuine Original Factory Ford Mustang
Gen5 Mk5 Front Xenon Headlights Headlamp HID D3S Ballast
(Xenon Light Control Unit / Module / Controller / ECU /
Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , D3R Osram Gas Discharge , Xenon Bulb Globes
, Projector Reflector Bowl , Plastic Lens Cover Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front( Fifth Generation)
Ford Mustang : 2-door
Convertible , 2-door Coupe
4.0 L (245 CID) Cologne V6
4.6 L (281 CID) Modular V8
5.4 L (330 CID) Modular Supercharged V8
V6 GT Boss 302 ,
Shelby 500GT , Shelby Convertible 500GT , GT500 , Bullitt
, Shelby GT500KR , 3.7L , 4.0L , 4.6L , 5.0L , 5.4L
If your 2008-2014 Ford Mustang OEM HID Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
xenon parts like: ballast, led bulb, control unit module
, reflector , or wire harness cable to repair and fix your
xenon light is ok, no need to cost a lot of money to buy
a whole brand new headlight assembly like the car dealer
suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|