2010-2012 Genuine Original Factory Ford Taurus
Xenon Headlights Headlamp HID D3S Ballast (Xenon Light Control
Unit / Module / Controller / ECU / Computer / Starter /Sation
/ Electronic Unit / Steuergerät /Inverter ) , D3R Osram
Gas Discharge , Xenon Bulb Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Sixth generation)
Ford Taurus 4-door
sedan : SE , SEL , Limited , SHO , 3.5L , 2.0L
2.0 L EcoBoost I4-T 240 hp (2013–2017)
3.5 L Cyclone V6 263 hp (2010–2012)
3.5 L Cyclone V6 288 hp (2013–2019)
3.5 L EcoBoost V6 365 hp (2010–2019)
3.7 L Cyclone Ti-VCT FFV V6 305 hp (Police Interceptor Sedan,
all-wheel drive only)
AG1313005BF,AG1Z13008C,AG1313005BH,AG1313005BG,AG1313005BJ,AG1Z13008C,DL3Z-13C170-A,AG1Z-13008-D,
AG1Z-13008-F , AG1Z-13008-H
If your 2010-2012 Factory Ford Taurus OEM HID Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
xenon parts like: ballast, led bulb, control unit module
, reflector , or wire harness cable to repair and fix your
led light is ok, no need to cost a lot of money to buy a
whole brand new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|