2015-2020 Genuine Original Factory Ford Yukon
Also Called : Chevrolet Tahoe Gen4 Front Xenon Headlights
Headlamp HID D3S Ballast (Xenon Light Control Unit / Module
/ Controller / ECU / Computer / Starter /Sation / Electronic
Unit / Steuergerät /Inverter ) , D3S Philips Gas Discharge
, Bulb Holder Ring , Wires Cable Harness , Projector Reflector
Foggy Bowl Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Fourth generation)
Ford Yukon : 4-Door
SUV
5.3 L Ecotec3 FlexFuel V8
6.2 L Ecotec3 FlexFuel V8
84564096 , 84564095 , 84294010, 84294009
LS, LT, LTZ, XL , SLE, SLT, Denali , 1500
If your 2015-2020 GMC Yukon OEM HID Bi-Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , or wire harness cable to repair and fix your
xenon light is ok, no need to cost a lot of money to buy
a whole brand new headlight assembly like the car dealer
suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|