
2003-2008 Genuine Original Factory Honda Accord
CM5 Saber Gen7 Mk7 Also Called : Honda Inspire JDM Front
Xenon Headlights LHD RHD Headlamp HID D2S D2R Ballast (Xenon
Light Control Unit / Module / Controller / ECU / Computer
/ Starter /Sation / Electronic Unit / Steuergerät /Inverter
) , D2R Gas Discharge Bulb Globes , Ignitor Ignition Scoket
Holder Wires , Plastic Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front Seventh generation (CM4/5/6/7/8)
North America and Asia Pacific
Honda Accord Mk7
: 4-door sedan (U.S. chassis no. CM4/CM5/CM6) ,
2-door coupe (U.S. chassis no. CM7/CM8, North America only)
Gasoline:
2.0 L K20A6 I4
2.4 L K24A4/K24A8 I4
3.0 L J30A4/J30A5 V6
3.0 L JNA1 V6 hybrid
DX-G, SE, EX-L, SE-V6, EX-L V6, EX-L V6
6MT , Hybrid , MY06 , Coupe , Saber
If your 2003-2008 Honda Accord Gen7 Mk7 JDM OEM HID Xenon
Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , igniter , or wire harness cable to
repair and fix your HID headlamps is ok, no need to cost
a lot of money to buy a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|