2013-2016 Genuine Original Factory Honda CR-V
Gen4 Mk4 Front Xenon Headlights Headlamp Assembly HID D2S
Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , D2S Philips Discharge Bulb, Igniter Cable
Socket , Xenon Bulb Globes , Signal Beam Projector Reflector
, Plastic Lens Cover , Leveling Motor Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light (fourth generation)
Honda CR-V RM1–RM4,
RE5–RE6 : 5 Door SUV , EX-L , VIT ,
Petrol:
2.0 L R20A I4
2.4 L K24Z I4
2.4 L K24W I4
Diesel:
1.6 L N16 I4 turbo
2.2 L N22B I4 turbo
2.0 L M/T, 2.0 L A/T, 2.4 L A/T and 2.4
L A/T Prestige. The 2.4 L A/T
If your 2007-2012 Honda CR-V OEM HID Xenon Headlight low
beam or Headlamp high beam have problems, like light failed
failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , igniter , or wire harness cable to repair and
fix your HID LED headlamps is ok, no need to cost a lot
of money to buy a whole brand new headlight assembly like
the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|