2004-2014 Genuine Original Factory Honda Elysion
RR1 RR2 RR3 RR6 Front OEM Xenon Headlights Headlamp Assembly
HID D2S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , D2S D2R Philips Gas Discharge Bulb, Igniter
Cable Socket , Xenon Globes Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (First-generation series RR1
thru RR6)
Honda Elysion :
5-door minivan
Petrol:
2.4 L K24A I4
3.0 L J30A V6
3.5 L J35A V6
VG, VX and VZ
Stanley HCHR-615 , STANLEY P7040 , STANLEY
P7026 , STANLEY P3877
If your 2004-2014 Honda Elysion OEM HID Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , igniter , or wire harness cable to repair and
fix your HID headlamps is ok, no need to cost a lot of money
to buy a whole brand new headlight assembly like the car
dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|