2008-2013 Genuine Original Factory Honda Mobilio
Spike Gen1 Front OEM Xenon Headlights Headlamp Assembly
HID D2R D2S Ballast (Xenon Light Control Unit / Module /
Controller / ECU / Computer / Starter /Sation / Electronic
Unit / Steuergerät /Inverter ) , D2R D2S Philips Gas Discharge
Bulb, Igniter Cable Socket , Xenon Bulb Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(First Second Generation)
Honda Mobilio Spike
: 5-door minivan Mobilio RS S E M/T , RS E CVT Prestige
Petrol:
1.5 L L15A2 i-DSI I4
1.5 L L15A1 VTEC I4
If your 2008-2013 Honda Mobilio Spike GB JDM OEM LED Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , igniter , or wire harness cable to repair and
fix your LED headlamps is ok, no need to cost a lot of money
to buy a whole brand new headlight assembly like the car
dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|