2003-2008 Genuine Original Factory Honda Odyssey RB1 RB2 Xenon Headlights Headlamp Assembly HID D2S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät /Inverter ) , D2S Philips Discharge Xenon Bulb, Igniter Cable Socket , Wires Cable , Bulb Holder Ring , Projector Reflektor Bowls , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Third Generation International)

Honda Odyssey (international) : RB1-RB2 chassis 5-door minivan , 2.4L

If your 2003-2008 Honda Odyssey RB1 RB2 JDM OEM HID Xenon Headlight low beam or Headlamp high beam have problems, like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enoug h , flashing . warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original led parts like: ballast, led bulb, control unit module , reflector , igniter , or wire harness cable to repair and fix your HID headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.