Genuine Original Factory OEM Hummer H1 H2
H3 Xenon Headlights Headlamp HID D1S Ballast (Xenon Light
Control Unit / Module / Controller / ECU / Computer / Starter
/ Electronic Unit / Steuergerät /Inverter ) , D1S Philips
Gas Discharge Xenon Bulb Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Hummer : H1, H2
, H3 (4-door pickup truck , 2-door pickup truck , 4-door
wagon , 4-door convertible - based on Humvee)
If your Hummer H1 H2 H3 OEM HID Xenon Headlight low beam
or Headlamp high beam have problems, like light failed failure,
flicker , dipped beam very dim dimmer, getting dimmer, not
working, flickering blinking , goes one and off , keeps
going out , flashlight , making noise , not bright enough
, not focused , stopped working , turning yellow and the
dashboard displayer have warning light , error code , go
up and down , moving up and donw , pointing down , distance
control defective , malfuncation ,turning pink , not turning
off , gone ping , turned purple ,turned pink , not bright
enoug h , flashing . warning light ,not working properly
, keeps burning out , have any other fault issues, you only
need to change or replace related original led parts like:
ballast, led bulb, control unit module , reflector , igniter
, or wire harness cable to repair and fix your HID headlamps
is ok, no need to cost a lot of money to buy a whole brand
new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|