2003-2006 Genuine Original Factory Infiniti
G35 V35 G35X Also Called : JDM Nissan Skyline Third Forth
Generation Xenon Headlights Headlamp Assembly HID D2S Ballast
(Xenon Light Control Unit / Module / Controller / ECU /
Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , D2S Philips Discharge Bulb, Igniter , Wires
Cable , Bulb Holder Ring , Projector Reflektor Bowls , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Infiniti G35 V35
Mk3 : 2-door coupe , 4-door sedan
3.5 L (3,498 cc) VQ35DE V6
26015-AC700 , 26060AM826 , 26060AM825 ,
26060CM40B , 26075-CM40C , 26060-AC70A , 26010AC725 , 26010-CM40C
, 26060AC725 , NA1K51030 , 26025-CM40C ,
If your 2003-2006 Infiniti G35 V35 Gen3 Origianl Xenon
HID Headlight low beam or Headlamp projector housing high
beam have problems, like light failed failure, flicker ,
bad , dipped beam very dim dimmer, dimming , got wet , getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , beam pattern problems
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , color inconsistency , color
temperature , go up and down , moving up and donw , pointing
down , overheating , distance control defective , leveling
malfuncation ,turning pink , condensation , not turning
off , gone ping , turned purple ,turned pink , trasig ,
not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|