2013-2017 SGenuine Original Factory Infiniti
QX50 J50 First Generation HID Xenon Headlights Headlamp
Assembly D2S Ballast (Xenon Light Control Unit / Module
/ Controller / ECU / Computer / Starter /Sation / Electronic
Unit / Steuergerät /Inverter ) ,Igniter D2S Philips Discharge
Bulb, Xenon Globes , Plastic Lens Cover Protector Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Infiniti QX50 :
5-door hatchback , 3.5L , 3.0L , 3.7L , 2.5L V6
3.5 L VQ35HR V6 (gasoline)
3.7 L VQ37VHR V6 (gasoline)
3.0 L V9X V6 (turbodiesel)
If your 2013-2017 QX50 OEM HID Xenon Headlight low beam
or Headlamp high beam have problems, like light failed failure,
flicker , dipped beam very dim dimmer, getting dimmer, not
working, flickering blinking , goes one and off , keeps
going out , flashlight , making noise , not bright enough
, not focused , stopped working , turning yellow and the
dashboard displayer have warning light , error code , go
up and down , moving up and donw , pointing down , distance
control defective , malfuncation ,turning pink , not turning
off , gone ping , turned purple ,turned pink , not bright
enoug h , flashing . warning light ,not working properly
, keeps burning out , have any other fault issues, you only
need to change or replace related original led parts like:
ballast, led bulb, control unit module , reflector , igniter
, or wire harness cable to repair and fix your HID headlamps
is ok, no need to cost a lot of money to buy a whole brand
new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|