2012-2016 Genuine Original Factory Kia Forte
Gen2 YD Also Called : K3 Cerato Koup HID Xenon Headlights
LHD RHD Headlamp Assembly D8S Ballast (Xenon LED Light Control
Unit / Module / Controller / ECU / Computer / Starter /Sation
/ Electronic Unit / Steuergerät /Inverter ) , D8S Osram
Discharge Bulb, Xenon Globes , Projector Reflector , Wires
Cable Harness Plastic Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Second Generation)
Kia K3 Forte Cerato
: 2-door coupé , 4-door sedan , 5-door hatchback
Petrol:
1.6 L Gamma MPi I4
1.6 L Gamma GDI I4
1.6 L Gamma turbo I4
1.8 L Nu MPi I4
2.0 L Nu MPi I4
2.0 L Nu GDI I4[32]
Diesel:
1.6 L U II CRDi I4
Koup SX , LX , S , EX , SX , SX Turbo
If your 2012-2016 Kia Forte K3 Cerato OEM HID Xenon LED
Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , igniter , or wire harness cable to
repair and fix your HID LED headlamps is ok, no need to
cost a lot of money to buy a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon LED control unit box ballast is ok, because from
our many years experience, when the headlight not work,
90% of the problem is on the ballast.
|