2023-2025 Genuine Original Factory KIA Telluride
4 LED Projector Headlights LHD RHD Headlamp Assembly Ballast
(LED Light Control Unit / Module / Controller / ECU / Computer
/ Starter /Sation / Electronic Unit / Steuergerät /Inverter
) , Plastic Lens Cover , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
KIA Telluride :
5-door SUV
3.8 L Lambda II GDi V6
If your 2023-2025 KIA Telluride Refresh OEM Full LED 4
Projector Headlight low beam or Headlamp high beam have
problems, like light failed failure, flicker , dipped beam
very dim dimmer, getting dimmer, not working, flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enoug h , flashing
. warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original led parts like: ballast, led bulb,
control unit module , reflector , igniter , or wire harness
cable to repair and fix your LED headlamps is ok, no need
to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit led control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|