2014-2015 Genuine Original Factory KIA K5
TF Facelift Also Called : Kia Optima HID Xenon Headlights
LHD RHD Headlamp Assembly D1S Ballast (Xenon Light Control
Unit / Module / Controller / ECU / Computer / Starter /Sation
/ Electronic Unit / Steuergerät /Inverter ) , D1S Philips
Discharge Bulb, Xenon Globes , Projector Reflector , Plastic
Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Third Generation )
KIA K5 TF : 4-door
sedan
Gasoline:
2.0 L Nu MPI I4
2.0 L Theta II MPI I4
2.0 L Theta II T-GDI I4
2.4 L Theta II MPI I4
2.4 L Theta II GDI I4
Gasoline/LPG:
2.0 L Nu LPI I4
2.0 L Theta LPI I4
Diesel:
1.7 L U II CRDi I4
Hybrid version
If your 2014-2015 KIA K5 TF Gen3 Mk3 Facelift OEM HID Bi-Xenon
Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , igniter , or wire harness cable to
repair and fix your HID headlamps is ok, no need to cost
a lot of money to buy a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|