2012-2016 Genuine Original Factory Kia K9
KH Mk1 Gen1 Also Called: Kia K900 , Kia Quoris HID Xenon
Headlights LHD RHD Headlamp Assembly D3S Ballast (Xenon
LED Light Control Unit / Module / Controller / ECU / Computer
/ Starter /Sation / Electronic Unit / Steuergerät /Inverter
) , D3S Philips Discharge Bulb, Xenon Globes , Projector
Reflector , Plastic Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(First Generation)
Kia K900 KA Mk1
: 4-door sedan
3.3 L Lambda II GDI V6
3.8 L Lambda II MPI V6
3.8 L Lambda II GDI V6
5.0 L Tau GDI V8
If your 2012-2016 Kia K9 K900 Mk1 OEM HID Bi-Xenon Full
LED Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , igniter , or wire harness cable to
repair and fix your HID LED headlamps is ok, no need to
cost a lot of money to buy a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon LED control unit box ballast is ok, because from
our many years experience, when the headlight not work,
90% of the problem is on the ballast.
|