2016-2020 Genuine Original Factory Kia Niro
Mk1 Gen1 DE Hybrid HID Xenon LED Headlights LHD RHD Headlamp
Assembly D1S Ballast (Xenon LED Light Control Unit / Module
/ Controller / ECU / Computer / Starter /Sation / Electronic
Unit / Steuergerät /Inverter ) , D1S Philips Discharge Bulb,
Xenon Globes , Projector Reflector , Wires Cable Harness
Plastic Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(First Generation)
Kia Niro Mk1 : 5-door
SUV
Engine
Petrol hybrid:
1.6 L Kappa II GDi I4
Petrol plug-in hybrid:
1.6 L Kappa II GDi I4
Electric motor
AC Synchronous Permanent Magnet Motor (hybrid and PHEV)
Permanent Magnet Synchronous Motor
If your 2016-2020 Kia Niro Mk1 Gen1 DE OEM HID Xenon Full
LED Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , igniter , or wire harness cable to
repair and fix your HID LED headlamps is ok, no need to
cost a lot of money to buy a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon LED control unit box ballast is ok, because from
our many years experience, when the headlight not work,
90% of the problem is on the ballast.
|