2021-2024 Genuine Original Factory KIA Niro
EV SG2 Mk2 Gen2 Full LED Projector Headlights LHD RHD Headlamp
Assembly Ballast (LED Light Control Unit / Module / Controller
/ ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , Plastic Lens Cover , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Second Generation)
KIA Niro EV Gen1
: 5-door SUV
Engine
Petrol hybrid:
1.6 L Smartstream G1.6 GDi HEV/PHEV I4
Electric motor Permanent Magnet Synchronous Motor
42 kW (56 hp) (HEV)
83 kW (111 hp) (PHEV)
150 kW (201 hp) (EV)
If your 2021-2024 Kia Niro SG2 OEM Full LED Projector Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , igniter , or wire harness cable to repair and
fix your LED headlamps is ok, no need to cost a lot of money
to buy a whole brand new headlight assembly like the car
dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit led control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|