2011-2016 Genuine Original Factory Kia Sportage
SL Mk3 Gen3 HID Xenon Headlights LHD RHD Headlamp Assembly
D1S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , D1S Philips Discharge Bulb, Xenon Globes ,
Projector Reflector , Plastic Lens Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Third Generation )
Kia Sportage SL
Mk3 : 5-door SUV
Petrol:
1.6 L Gamma GDi I4
2.0 L Theta II I4
2.0 L Theta II turbo GDi I4
2.4 L Theta II I4
2.4 L Theta II GDi I4
Diesel:
1.7 L U CRDi I4
2.0 L R CRDi I4
If your 2011-2016 Kia Sportage Mk3 OEM HID Bi-Xenon Headlight
low beam or Headlamp high beam have problems, like light
failed failure, flicker , dipped beam very dim dimmer, getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , making noise , not
bright enough , not focused , stopped working , turning
yellow and the dashboard displayer have warning light ,
error code , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , have any other fault
issues, you only need to change or replace related original
led parts like: ballast, led bulb, control unit module ,
reflector , igniter , or wire harness cable to repair and
fix your HID headlamps is ok, no need to cost a lot of money
to buy a whole brand new headlight assembly like the car
dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|