2017-2025 Genuine Original Factory KIA Stinger
LED Projector Reflector Headlights LHD RHD Headlamp Assembly
Ballast (LED Light Control Unit / Module / Controller /
ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät
/Inverter ) , Plastic Lens Cover , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
KIA Stinger CK :
5-door liftback/fastback sedan
Gasoline:
2.0 L Theta II T-GDi I4[7]
2.5 L Smartstream FR G2.5 T-GDi I4
3.3 L Lambda II T-GDi V6[7]
Diesel:
2.2 L R II CRDi I4[8]
If your 2017-2025 KIA Stinger OEM Full LED Projector Reflector
Headlight low beam or Headlamp high beam have problems,
like light failed failure, flicker , dipped beam very dim
dimmer, getting dimmer, not working, flickering blinking
, goes one and off , keeps going out , flashlight , making
noise , not bright enough , not focused , stopped working
, turning yellow and the dashboard displayer have warning
light , error code , go up and down , moving up and donw
, pointing down , distance control defective , malfuncation
,turning pink , not turning off , gone ping , turned purple
,turned pink , not bright enoug h , flashing . warning light
,not working properly , keeps burning out , have any other
fault issues, you only need to change or replace related
original led parts like: ballast, led bulb, control unit
module , reflector , igniter , or wire harness cable to
repair and fix your LED headlamps is ok, no need to cost
a lot of money to buy a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit led control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|