2006-2010 Genuine Original Factory Land Rover Freelander 2 Also Called LR2 or Freelander 2 HID Bi-Xenon Adaptive Headlight Headlamp Assembly D1S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät /Inverter ) , D1S Philips Discharge Bulb, Plasitc Lens Cover , Wires Calbe Harness Connector , Projector Reflector , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Second Generation)

Land Rover Freelander Gen2 : 5-door SUV

Petrol:
2.0 L Ford EcoBoost 243 PS I4
3.2 L Volvo SI6 233 PS I6
Diesel:
2.2 L Ford Duratorq 150 PS eD4
2.2 L Ford Duratorq 160 PS TD4
2.2 L Ford Duratorq 190 PS SD4

If your 2006-2010 Land Rover Freelander LR2 HSE L359 HID Bi-Xenon Headlight low beam or Headlamp high beam have problems, like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enoug h , flashing . warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original led parts like: ballast, led bulb, control unit module , reflector , igniter , or wire harness cable to repair and fix your LED headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.