2013-2017 Genuine Original Factory Lexus LS460L LS600HL
XF40 HID Bi-Xenon Triple Beam LED Projector Headlights LHD
RHD Headlamp Fourth Generation Assembly D4S Ballast (Xenon
Light Control Unit / Module / Controller / ECU / Computer
/ Starter /Sation / Electronic Unit / Steuergerät /Inverter
) , D4S Philips Gas Xenon Bulb , Wires Cable , Bulb Holder
Ring , Projector Reflektor Bowls , AFS Motor , Plastic Lens
Cover Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Lexus LS460 LS600
: 4-door sedan
4,608 cc (281 cu in) 1UR-FE V8
4,608 cc (281 cu in) 1UR-FSE V8
4,969 cc (303 cu in) 2UR-FSE V8 hybrid (LS 600h)
If your 2013-2017 Lexus LS460L LS460HL XF40 HID Bi-Xenon
Triple Beam LED Headlight low beam or Headlamp high beam
have problems, like light failed failure, flicker , dipped
beam very dim dimmer, getting dimmer, not working, flickering
blinking , goes one and off , keeps going out , flashlight
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , go up and down , moving up
and donw , pointing down , distance control defective ,
malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enough , flashing
. warning light ,not working properly , keeps burning out
, have any other fault issues, you only need to change or
replace related original xenon parts led like: ballast,
xenon bulb, control unit module , reflector , igniter ,
or wire harness cable to repair and fix your xenon led headlamps
is ok, no need to cost a lot of money to buy a whole brand
new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon led control unit box ballast is ok, because from
our many years experience, when the headlight not work,
90% of the problem is on the ballast.
|