2014-2021 Genuine Original Factory Lexus NX200T NX300H AZ10 OEM Triple Beam Single LED Projector Headlights LHD RHD Headlamp Ballast (LED Light Control Unit / Module / Controller / ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät /Inverter ) , Plastic Lens Cover Protector, LED DRL Assembly , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front(First generation)

Lexus NX200 NX300 : 5-door SUV

Engine
Gasoline:
1986 cc 3ZR-FAE I4 (NX 200; ZGZ10)
1998 cc 8AR-FTS turbo I4 (NX 200t/300; AGZ10/15)
Gasoline hybrid:
2494 cc 2AR-FXE I4 (NX 300h; AYZ10/15)
Electric motor
105 kW (141 hp; 143 PS) 2JM synchronous (NX 300h, front)
50 kW (67 hp; 68 PS) 2FM synchronous (NX 300h, rear)

If your 2014-2021 Lexus NX200T NX300H AZ10 LED Single Triple Beam Projector Headlight low beam or Headlamp high beam have problems, like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enough , flashing . warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original led xenon parts like: ballast, xenon bulb, control unit module , reflector , igniter , or wire harness cable to repair and fix your xenon led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.