2007-2012 Genuine Original Factory Mazda CX-7 Xenon HID
Headlamp Assembly D2S D2R Ballast (Xenon Light Control Unit
/ Module / Controller / ECU / Computer / Starter /Sation
/ Electronic Unit / Steuergerät /Inverter ) , D2S Philips
Discharge Bulb Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Mazda CX-7 : 4-door
SUV , 2.2L , 2.3L , 2.5L , iSV , iSport , sTouring , sGrand
Touring , GS , GT
If your 2007-2012 Mazda CX-7 HID Xenon headlight have problems
like: light failed failure, very dim dimmer, dipped , waring
light , dipped beam, keeps going out , not working, flickering
, error , fault , goes on and off out , go up and down ,
moving up and donw , pointing down , distance control defective
, malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enoug h , flashing
. warning light ,not working properly , keeps burning out
, or have any other issues, you only need to change or replacement
original xenon parts like: ballast, gas discharge bulb,
igniter or wire harness, cable to repair your HID headlamp
is ok, no need to cost a lot of money to buy high price
a whole brand new headlight assembly like the car dealer
suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|